System Integration

In the System Integration category, you will find all information you need to know about System integration solutions on the market. In this section, we are going to review solutions, make comparisons and write articles.

Q&A System Integration 1 min

EtherNet/IP – RotaMASS Total Insight

I have a plant with digital communication, we have EtherNet/IP already applied and some Endress+Hauser and Emerson Flow meter. My question is related to Yokogawa solution to ethernet protocol, can you information if they already have a Coriolis with EtherNet/IP? ...
Q&A System Integration 1 min

4-20 mA loop test

How do I do the loop test? I'm working in a plant startup, and I need to do the loop test on all our 4-20 mA field devices. ...
Field Network Flow Q&A System Integration 1 min

How to integrate a Promag 100 into EtherNet/IP

How do I integrate a Promag 100 into a Rockwell system based on Ethernet/IP? ...
Flow Q&A System Integration 1 min

How to integrate PROMASS 100 into EtherNet/IP

How to integrate the PROMASS 100 into my Rockwell system? Is there a specific procedure to do the implementation? ...
Q&A System Integration Temperature 1 min

RTD failure: What to do if the sensor breaks?

If the RTD sensor broke, what will happen? I found the signal in the PLC display didn't change after I disconnect the sensor, I am afraid if the sensor fail in someday and the interlock will not active. ...
Q&A System Integration 1 min

Burst mode go!

Can you explain burst mode to me? I have a field panel device, and I want to convert the HART signal to three-wire analog output. But for that, I need to configure the burst mode on the field device. Why do I need to do that? ...
Flow Q&A System Integration 1 min

Pulse or analog for custody transfer?

Since most Coriolis transmitters provide both pulse and analog 4-20 mA outputs for the reading, which works better for liquid custody transfer where the reading goes to a flow computer and why? How about the digital HART output from the transmitter? ...