Rosemount Raptor? Sounds like a new species. And where can you find one? At Emerson, of course! Emerson’s Rosemount Raptor is a system with a bunch of devices: radar, pressure, temperature, communication, inventory management, death lasers whoops, not that one. When you say wireless Raptor, you mean the THUM adapter with the 1420 gateway, I’m sure. Anyhow, you’ve come to the right place to configure a Rosemount Raptor!

Rosemount Raptor configuration

Now, the wireless config usually follows the same steps as most of your devices, has standard network protocol, can use different brands, yadda yadda. But! You have two configs to make the bits chat with each other: the Network ID and the Join Key.

rosemount raptor wireless configuration diagram
Rosemount™ Tank Gauging System – Courtesy of Emerson Automation Solutions

So the Network ID is the … ID … of the network. Yeah. Anyway, it has to be unique. All authenticated wireless gizmos with the same ID can talk to the same network and gateway. “Authenticated” is the keyword here.

The Join Key is a 128-bit security code for authenticating your gizmos on the network. Now, everyone can use the same Join Key on a network, or each gizmo may have a unique Join Key. Either way, these configs keep creepers from creeping on your network through your gizmos.

So. Howzit go? Here we go!

Gateway steps

  1. Go to the gateway and connect using an Ethernet cable (yeah, I know, just deal).
  2. Find the maintenance port (it usually has the IP or
  3. Set up in the same IP range (you should know how this bit works).
  4. Connect to the gateway using the web browser (put the gateway IP here).
  5. Put in the username and password (yup, user: admin, password: default).
  6. Set up the Network ID and Join Key (almost there!).
  7. Your gateway is ready to find your gizmos (tada!).

THUM steps

      1. Figure out what setup you need with the THUM (see pretty picture).

        THUM - Configure a Rosemount Raptor
        THUM installation
      2. Connect the handheld to access the THUM config (deedledeedledee).
      3. Put in the default HART polling address, 63 (if that doesn’t work I got nothin’).
      4. Set up the THUM using the same Network ID and Join Key you set up on the gateway (if you haven’t yet, why are you jumping ahead? Go back!).
      5. If you can’t use the handheld, check the Device Description files (the HART knows best).
      6. After the setup, the THUM will find the gateway and you can finish remotely (yay!).

That should do it- that’s how you configure a Rosemount Raptor!

More information on how to configure a Rosemount Raptor

If you need the tech manuals, check the Rosemount wireless gateway – 1420 or the Rosemount Wireless adapter – THUM.

And you can see the market’s current wireless solutions here:

Other resources that might interest you

THUM with Rosemount 8712
We have a wirelessHART network, and now I need to add a new flow meter to the network. What do you recommend for THUM installation?

Rosemount 8712 and another flow sensor
Can you have a Rosemount 8712 installed with another brand sensor?

Rosemount 8732 communication!
I can’t get communication between my handheld and the Rosemount 8732. Can you tell me why they’re not talking to each other?

K-factor for Rosemount 8712
The measurement of my flow meter is not correct, and we’re investigating what’s happening here. Can you tell us how to check the K-factor on the transmitter?f

Recommended articles

The most important benefits of the HART 7 communication protocol

Articles Data Acquisition Industry 4.0 Wireless