Yes, of course, we can show you how to check the K-factor for Rosemount 8712. This one is very easy. On the interface of the transmitter, you should find a button labeled “Tube Cal No.” Press that and, voila! It will show you the K-factor right away.

Now, if you want to access the configuration using a handheld, then use the following steps:

Device > Basic Setup > Calibration Number.

That should give you exactly the same figure as the Tube Cal No. button.

If you want to read more about the 8712 setup, click here!

Magmeter on the market:

Other resources that might interest you

Rosemount 8712 damping time
What’s the maximum Rosemount 8712 damping time?

Rosemount 8712 testing
I want to test my transmitter conditions. Is there a tool that can simulate a flow meter?
Rosemount magnetic flow meter 8712 – low flow cutoff
I need to change our cutoff value because our magmeter is measuring without flow. How do you change the low flow cutoff on a Rosemount magnetic flow meter 8712?
Rosemount 3051S installation
We want to lower the temperature that our Rosemount 3051S is exposed to. How far away can we move the device from the process?
Recommended articles