Expert’s answer: Micro Motion 5700 configuration

Sure do! You can do a Micro Motion 5700 configuration with a handheld or through the local display. Of course, I have to tell you that you can find this sort of information in the manual. Nonetheless, I’m here to support you and make your life easier!

Micro Motion 5700 configuration
Micro Motion 5700 – Courtesy of Emerson Automation Solutions

For this case, I’ll follow the device menu through the local display and based on a HART transmitter. If you want to change the units of your density, pressure, volume, or others, then you’ll follow a similar path. But after the flow variables, you’ll go to pressure, volume, or whatever you want to change.

The step by step below will change the mass flow unit:

  • Menu > Configuration > Process Measurement > Flow Variables > Mass Flow Settings > Units

That should take care of it!

Coriolis on the market:

Other resources that might interest you

Micro Motion 5700 pulse setup
How can you set up the pulse output in the Micro Motion 5700?
Remote installation – Micro Motion 5700 manual
How do you do a remote installation of the Micro Motion 5700?
Micro Motion 5700 mass flow accuracy
Can you tell me the standard accuracy of the Micro Motion 5700 for mass flow?
Recommended articles