HART pressure transmitter: How to set up two displays
Hello. I have a HART pressure transmitter in the field, and I want a setup for two displays in different locations for the same pressure device. Can I do that? I'm using only the 4 - 20 mA. ...
Millivoltage for type K thermocouple?
How can I find the millivoltage for the temperature in a type K thermocouple sensor? ...
Orifice plate or vortex for steam flow meter?
I need a new flow meter for steam measurement. I know we can use a vortex flow meter or an orifice plate. Which do you recommend? ...
Coriolis installation for gas application
Hey. We’re installing a new Coriolis in a gas application. Should we have inlet and outlet runs? What's the correct installation for gas? ...
Flow meter for process water
Hello. I need a flow meter, but I don't know exactly which type. The product will be process water with a maximum flow range of 100 m³/h and ambient temperature. It won't need much accuracy because it's just a monitoring application. Can you help? ...
WirelessHART configuration basics
We're implementing a new wirelessHART network in my plant, and it's my first time using this kind of technology. Could you go through the basic configuration with me? ...
HART flow device configuration with a handheld
Hi! I bought a new HART flow device, but I can't configure it using my handheld. Is it not possible to configure an Endress+Hauser device using an Emerson 475 field communicator? ...
Multipoint temperature measurement
We’re working on a project to measure 36 temperature points, but we only have 5 HART inputs in our PLC. We’d like multipoint measurement if we can get it. Do you have any suggestions? ...
Pressure transmitter data
Hi. I bought a pressure transmitter S/N K219C601052 from Endress+Hauser, but I don’t know if the transmitter is providing the data I requested. Could you check for me? Thanks. ...
Thermal mass flow application
Hey. I want to use the t-mass 150 in my process, but I have a question about our application. Our blower runs for about 2 to 5 minutes about every 20 minutes. During the 20-minute intervals, the process won’t have air flow and pressure in the line. Will this have any effect on our vortex flow mete ...