Display information – PROMASS 100

Flow Q&A

Which kind of information can I have on the display? I mean, I would like to setup the flow rate and the totalization of my display, is it possible?


Expert’s answer: Display information – PROMASS 100

Sure! It’s possible setup both the flow rate and also the totalization on the display in the Promass 100. However, you can’t configure the display settings within the display itself. The display is only for visualization. If you want to change the settings you will need a laptop or handheld.

Courtesy of Endress+Hauser

The configuration is simple. The flow meter has a built-in web server with which you can do the configuration using a laptop without a specific software. You do not have a laptop or it is not possible to access the field with the laptop? No problem, you can make the setup the display with a handheld just as well.

Other resources that might interest you

Coriolis mass flow reading variation
What if there’s a variation in your Coriolis mass flow reading?

4-20 mA on Micro Motion 1700
What to do if the output isn’t working properly for a Micro Motion 1700 and you can’t access the device with the handheld?

Unreliable density reading
You have a CMF300 with 3500 RF Micro Motion Coriolis, but it’s not reading correctly. What can you do?

ROTAMASS Total Insight installation
How do you install the ROTAMASS Total Insight Coriolis from Yokogawa?

Related tags: Coriolis Flow flow application flow measurement PROMASS 100
Comments
Display information - PROMASS 100
#LinkeInsights: Base Conditions for Orifice Calculation
Seven Vortex Flowmeters you should know
#LinkedInsights: Maximum Uncertainty of Orifice Plate Flowmeters AGA-3
Watch Out, it's Oxygen! Precautions for Choosing Flowmeters for Oxygen Service
See related devices