Can you do a Promag 400 loop test with the display?

Flow Q&A Services

Hi! I want to do a loop test on my Promag 400. How can I do it using the display directly?

Expert’s answer: Can you do a Promag 400 loop test with the display?

You’d think that a Promag 400 loop test would be simple. Just look it up in the manual, right? Except for some reason the Endress+Hauser manual calls the loop test a simulation! Come on, E+H! Everyone else says output! Why you gotta be difficult?

Promag 400 loop test
Magmeter – Courtesy of Endress+Hauser

As soon as you grasp the special terminology for your procedure, you can follow these steps to simulate the current output:

  • Menu > Diagnostic > Simulation > Simulation current output

You can simulate a bunch of other stuff too, like your process values and whatnot. And luckily, you can find all those options in this here menu. So go for it! Start simulating!

Magmeter on the market:

Other resources that might interest you

Do you need to do a loop test to check communication?
Do you need to do a loop test to check the communication if you’re using a HART device?

Promag 400 damping options!
Does a flow meter have two different kinds of damping options? 

Distance between sensor and transmitter – Promag 400
How far can I install a remote Promag 400 from a sensor? Is there a distance limitation?

Changing flow units on Promag 400?
How do you change flow meter units using a display and a field communicator?

Related tags: current output Electromagnetic loop test Magmeter magnetic flow meter Volumetric Flow
Comments
Can you do a Promag 400 loop test with the display?
#LinkeInsights: Base Conditions for Orifice Calculation
Seven Vortex Flowmeters you should know
#LinkedInsights: Maximum Uncertainty of Orifice Plate Flowmeters AGA-3
Watch Out, it's Oxygen! Precautions for Choosing Flowmeters for Oxygen Service
See related devices