Temperature transmitter class T3!

Q&A Temperature

I am trying to install a thermowell into my process to measure the temperature of the flue gas. All temperature transmitters are in compliance with temperature class T3 means they support up to 200 degree Celsius. The surface of the application is higher than 200 degrees Celsius, is that a problem to implement a temperature transmitter?

Expert’s answer: Temperature transmitter class T3!

Ouch! Hot, hot, hot! I feel your pain, my friend. Not to worry, though! Actually, you don’t need to install the temperature transmitter  class T3 on the pipe surface. If you buy a remote transmitter, then you can set it anywhere you please, like in a cooler temp that the device can handle.

Temperature Transmitter – Courtesy of Emerson Automation Solutions

You can also ask the manufacturer for a heat sink. Get the company to build a long neck between the sensor and the transmitter. Then your electronics will hang out far enough away from the heat to avoid problems. It may look odd, but who cares?

Regardless which route you take, you can find plenty of devices on the market to solve your dilemma on the cheap. Check ’em out!

Temperature transmitters:

Other resources that might interest you:

Rosemount 3144P temperature transmitter
Do you need to calibrate or adjust the transmitter to read the same temperature as the probe if you have a Rosemount 3144P with a range of 0 to 150 degrees Fahrenheit?

How to use thermocouple basics to test a thermocouple loop
How do you test a thermocouple loop by injecting a millivoltage from the field?

Related tags: high temperature Installation recommendation Temperature temperature transmitter transmitter
Comments
Temperature transmitter class T3!
Product Comparison: Temperature Transmitters
Product Review: Endress+Hauser Thermophant T TTR35
Water well level measurement with Proteus EcoMeter
Product Review: Endress+Hauser iTHERM TM401
See related devices