Expert’s answer: ProLink and Smart Meter Verification

Using your ProLink and Smart Meter Verification shouldn’t be too big a hassle. First of all, you need to connect the ProLink with the Coriolis, using the Modbus. Then, you need the interface for the RS-485 communication between your laptop and your field device. Usually, Emerson will provide a Black Box to connect them.

Now, you need to set up the basics, like the protocol, baud rate, parity, and stop bits. You also need access to the Smart Meter Verification report and the license for the ProLink.

If you want, you can use the HART communication to make your connection, but usually you’ll do it with the Modbus. The ProLink manual has a list of devices supported by Modbus and HART communication.

Want more information on flow meter verification? If so, check out these options on the market:

Other resources that might interest you

Field Communicator and the SMART Meter verification
Can you use a SMART meter verification with a field communicator? Here’s what you need to know!

Coriolis Smart Meter Verification
Can I use my display to run my Smart Meter Verification? Find out here.

Smart Meter Verification for magmeter?
How does SMART Meter Verification actually do for a magmeter? Want to know more? Then, click through to find out.

AMS Suite and Smart Meter Verification
Can you access an AMS Suite with a Coriolis with Smart Meter Verification? But if not do you need to buy software?

Empfohlene Artikel